Direct Shear TestsIntroduction:
An accurate determination of soil shear strengths in the laboratory is essential to cost effective design and planning for geotechnical projects. One such laboratory method available at MEA is the Direct Shear Test. The test is commonly employed for geotechnical projects where soil shearing along a horizontal plane is anticipated. This applies to landslide remediation, slope stabilization, and pipeline analysis projects. The direct shear machine at MEA can perform tests over a large range of strain rates ranging from 0.00001 to 0.49999 in/min; these rates are suitable for both geotechnical and research projects. MEA’s direct shear machine offers a more customizable strain rate than standard direct shear apparatuses whose rates range from 0.0001 to 0.3 in/min. Figure 1 is a picture of our direct shear machine.
The purpose of a direct shear test is to determine the shear strength of a soil; this is done by forcing the soil to shear along an induced horizontal plane of weakness at a constant rate. A minimum of three subtests are run where the sample is consolidated using three different weights and then sheared at the same constant rate. The peak shear stress and residual shear stress of each subtest are recorded and graphed. Using this data, the cohesion and friction angle of the soil can be determined. Figure 2 below shows an example test plot with five separate subtests used to complete the test. The soil in question had no cohesion and a peak friction angle of 40.5º and a residual friction angle of 37.9º.
Tags: direct shear, direct shear test, soil and rock laboratory, soil testing
Trackback from your site.